Will Baking Soda And Vinegar Dissolve Hair?

Here are some ways you can use to clear that problem, whether you have a hair clog in your bathroom sink, shower, or tub drain.

Use Baking Soda and Vinegar

A particularly potent mixture that can help eliminate unpleasant hair clogs is baking soda and vinegar. Baking soda not only aids in the dissolution of hair in your drain but also has antifungal and antibacterial properties. Following are the instructions for using vinegar and baking soda to unclog drains:

  • Pour one cup of baking soda and then one cup of vinegar down the clogged drain. Fizzing will result from the chemical reaction caused by this.
  • Pour one litre of boiling water down the drain around ten minutes after the fizzing stops.
  • To check if the water is adequately draining, turn on the faucet.
  • Repeat the first three procedures if the drain is still clogged. For more difficult hair clogs, you might need to repeat the method multiple times.

Use Needle-Nose Pliers or a Wire Hanger

Using pliers or a wire hanger could be a wonderful way to pull hair out of the drain if your drain has a removable cover. You will require needle-nose pliers, rubber gloves, a screwdriver, and a flashlight for this.

  • Drain stopper should be removed. Use the screwdriver to remove the stopper if you are unable to do it manually.
  • Use a flashlight to locate the obstruction.
  • Put on your gloves and take out the needle-nose pliers to remove the hair clump.
  • Try using a wire hanger if the pliers can’t fit the drain or reach the obstruction. Just construct a hook at the end of a coat hanger after straightening it up. Find a hair clump, fish around for it in the drain, and pull it out.
  • Flush the drain with one litre of hot water after it is clear.

Use a Plumbing Snake

A plumbing snake, also referred to as an auger, is just a flexible, long wire or plastic tool used to rapidly and effectively unclog obstructions in drains. You can purchase one from your neighbourhood hardware store if you don’t already have one. Depending on the intended usage, augers come in a wide variety of sizes and designs.

Here are some factors to think about while selecting an auger:

  • Augers are available in a few common lengths and cable thicknesses. A 25-foot cable that is at least 1/4 of an inch thick should work for the typical homeowner or renter who wishes to unclog a shower, tub, or sink. An auger with a 50-foot cable would be great to reach obstructions in longer pipes in multi-story homes with bathrooms upstairs.
  • Drain snake head style: There are two basic head designs for plumbing snakes: cutting heads and coil heads. You can seize hair clumps and remove them from the drain by using tools with coil or toothed heads. Cutting heads contain razor-sharp blades that easily remove any obstructions in a pipe.
  • Using manual augers, you push the snake down the drain, crank the handle to grab the obstruction, and then draw the snake out. The cable can be advanced and retracted by electric drain snakes with just the push of a button; this is a better approach to clearing out large obstructions.

Although there are many different types of augers available, DrainShroom is the finest choice (but we admit, we might be biased). This ground-breaking clog buster, which costs only $14.99, attaches to any power drill and digs deep into your bathtub, shower, or bathroom sink drain. Here is more information about using drain snakes.

Use a Plunger

Some of the most popular household appliances for unclogging drains include plungers. There are several various types of plungers available, each made to work with a certain type of drain.

Use a sink or common plunger for drains in bathtubs, showers, or sinks. A rubber cup is attached to the end of a wooden or plastic handle on this type of plunger. Since the cup needs to sit flat over the drain, it works best on flat surfaces like a sink or bathtub.

Here’s how to unclog a drain using a plunger:

  • Plunge the drain while doing so.
  • Fill the tub, shower, or sink with water until the plunger is completely immersed.
  • In a brief period of time, pump the plunger up and down six or seven times.
  • To check if the water drains away, remove the plunger from the drain opening. If it doesn’t, try it again.
  • Pour one litre of water down the drain to rinse out any debris after the clog has been removed.

You can attempt a chemical drain cleaning if everything else fails. Green Gobbler, SuperFast Drain Cleaner, Liquid Fire, Drano Max Gel, and Pequa Drain Opener are a few of the most well-known goods. Make care you read and abide by the usage instructions. Don’t make the error of combining commercial or homemade cleaners with drain cleaners. An explosion or a hazardous gas could result from the chemical reaction.

If over-the-counter medications and chemical cleaners are ineffective, it’s time to call in expert plumbing services. They can clear even the toughest clogs consisting of hair, grease, soap scum, grime, and other material using their drain cleaning technology and gear. Pick a qualified, insured, and licenced plumber. Additionally, make sure to read consumer testimonies and reviews posted online.

How much time does it take vinegar and baking soda to breakdown hair?

  • Use Baking Soda and Vinegar Before Splashing It Out: Baking soda and vinegar are quite efficient at clearing out a variety of clogs, including hair clogs. Start by pouring a little dish soap down your drain, then add a cup of vinegar and a cup of baking soda for the greatest results. Wait about five minutes for the vinegar and baking soda to react chemically, and then follow that with a cup or more of hot water. You should still use a cup plunger on your drain to remove any remaining hair after doing this to clear away the majority of the hair clog. Make sure you are particularly utilising a cup or “flat” plunger, and repeat this procedure as required if the obstruction is still present.
  • Pull It Out Using Tweezers: Unlike heavier clogs, hair can occasionally be challenging to dig out because to its stringy nature. If you have attempted to remove a hairy obstruction from your drain by plunging it out but have been unsuccessful, you may need to try tugging it out with a pair of tweezers. If your drain has a stopper, you must first remove it. Depending on the type of your drain, you might need to do this by hand occasionally, however you might also require a screwdriver. While you’re at it, you might as well clean any accumulated hair off the stopper as well. After that, use a flashlight to throw light into your drain so you can see the obstruction more clearly. You should then be able to remove that nasty buildup of hair with your needle-nose pliers. As pulling hair out can be quite unpleasant, you might want to use gloves as you go about this process. After you’re done, you should also pour some hot water down your drain to flush any newly formed hairs out.
  • Buy a Snaking Device: If using baking soda and vinegar to melt your hair clog, plunging it out, and using tweezers to remove it haven’t worked, you might be able to break that clog apart with a snaking device. Which type of snake do you ask? Depending on how bad your clog is, you may have a variety of solutions. Straightening out a wire hanger and inserting it down your drain to clear a clog can work in less serious situations. Sometimes you might want to invest on a zip-it tool. These disposable plastic drain cleaners are affordable, simple to use, and easily accessible online. You may also buy a variety of alternative drain snake tools at your neighbourhood hardware shop or online, all of which are made to handle obstructions of various sizes. However, you might also want to follow up with the baking soda and vinegar method described above or at the very least flush your drain out with hot water to make sure the blockage is entirely gone. Snaking your drain should efficiently break up any jams and assist scrape the walls of your line clean.
  • The final and most intensive home cure for clearing a hair clog is to remove your entire drain. After using each of the aforementioned ways without success, you might completely remove your drain and attempt to clear it out that way. Remove the p-trap (the p-shaped drain pipe beneath the sink designed to vent sewage gases) in the case of your sink drain, positioning a bucket below for any water that may leak out. A plug wrench, a tool made specifically to fit into your drain’s crossbars so you can easily pry it out, is required to remove the drain from your shower or bathtub. Use rubber hands once more whenever you are removing a drain because it is a really unkempt job. If you find all of this to be too challenging or you don’t feel confident handling this much plumbing work by yourself, you can also…
  • Call for Professional Drain Cleaning: Although clearing a hair clog can be challenging, Smith’s Plumbing Services offers professional drain cleaning services if all else fails. We can clear clogs consisting of hair, soap scum, grease, food, toilet paper, and a variety of other difficult-to-remove objects using our drain cleaning gear and technology. Remember to avoid using liquid drain cleaners at all costs. These treatments include hazardous chemicals that will corrode your pipes in addition to their propensity for being ineffectual, frequently sitting on top of clogs rather than eating through them. Try one of our DIY drain cleaning techniques instead, or contact Smith’s anytime for assistance. Even for emergencies, we’re here around-the-clock!

Make a reservation for drain cleaning right away by dialling (901) 290-1110. Additionally, you can contact us online.

How Do I Unclog My Drain?

Victory! must be shouted as you smash the toughest blockages into mush and flush them down your pipes.

However, not every blockage calls for such fuss. Sometimes clearing odorous drain clogs and clearing drains only requires routine drain cleaning and a slight shove.

Introducing vinegar and baking soda. While they can sometimes clear clogs, Liquid-Plumr is your best option when home remedies fall short. Read on!

Step 4:

Step 3’s bubbling reaction between the baking soda and vinegar aids in unclogging the drain, and step 4’s boiling water aids in flushing the obstruction from your pipes.

A natural drain cleaner can be made using baking soda and vinegar. Are you ready to learn how it works scientifically?

The Science: How Baking Soda & Vinegar Help Unclog Drains

Sodium bicarbonate, or baking soda, is a base. Water and acetic acid, an acid (you guessed it), are the two main ingredients of vinegar.

Combining these causes a reaction in which molecules are exchanged, resulting in the production of carbon dioxide and water that bubble through the obstruction, dislodging it to produce loose material.

And unlike a regular water system, drainage pipes are not pressured. Pressure is increased when hot water is used to flush the drain. This pressure helps unclog drains and remove undesirable crap from pipes in addition to gravity.

Baking soda, vinegar, and boiling water can all be used to naturally clean drains, but you might need something more powerful, such as Liquid-Plumr, to completely clear out those very stubborn clogs.

Benefits of Using Baking Soda & Vinegar as a Drain Cleaner

The advantages of routine drain cleaning can help keep your drains clear of clogs, and over time, baking soda and vinegar may operate as a natural drain cleaner on weaker drain jams.

However, you might want to use a more potent drain cleaner, such as Liquid-Plumr, for stubborn drain clogs that need to be cleared right away.

Cleaning Tough Drain Clogs

Products from Liquid-Plumr can unclog stubborn drain clogs more effectively than home cures while still being safe to use in your pipes.

In order to help unclog difficult drains, Liquid-Plumr Clog Destroyer+ PipeguardTM has two potent liquids that, when mixed, produce a deep-cleaning foam that dissolves hair and odour throughout the whole pipe.

To efficiently dissolve the drain obstruction, the main active ingredients sodium hydroxide and sodium hypochlorite emit heat. That is pretty strong science, indeed!

Do vinegar and baking powder dissolve hair?

As a homeowner, there are several actions you can do to keep hair and soap scum out of your shower drain. While these methods work well for routine maintenance and can help clear smaller, less serious blockages, they shouldn’t be utilised to repair a main sewage line obstruction because doing so could cause long-term damage.

Boiling Water

flushing your shower drain with boiling water. This is a fantastic initial step to take because the water’s temperature aids in more successfully breaking up the soap scum and grime buildup so that it may be thoroughly washed away. This can prevent clogs if you do it once a week.

Plunger

Hair obstructions may be successfully released by using a plunger. Petroleum jelly lining the plunger seal will aid in improving air suction, increasing the plunger’s effectiveness. The greatest thing you can do to prevent hair blockages is to simply remove hair stuck in the drain cover after each shower. Regularly using a plunger will prevent hair build-up.

Baking Soda and Vinegar

More than just a plunger may be required for a larger, deeper obstruction. Without using harsh chemicals, you can dissolve hair clogs naturally by combining vinegar and baking soda. First, pour a cup of baking soda down the clogged drain, and then add a cup of vinegar after a few minutes. After letting the combination dissolve the obstruction for a few hours, flush the drain with boiling water.

Chemical Drain-Cleaning Products

Although using caustic drain-cleaning chemicals on a daily basis may seem like a quick and inexpensive way to fix your clogged drain, doing so can harm your pipes and shower fittings, be harmful to your health, and pollute the environment. It’s probably time to call in the pros if your drain is so blocked that you’re thinking of employing these hazardous chemicals.